Banner U-Gage Ultrasonic Sensor Uživatelský manuál stáhnout pdf (Strana 52)

LIGHT GAUGING

ULTRASONIC

MEASURING

ARRAYS

EZ-ARRAY

High-Resolution

MINI-ARR AY

RADAR

More information online at bannerengineering.com 343

Photoelectrics

Sensors

Fiber Optic

Sensors

Special Purpose

Sensors

Measurement &

Inspection Sensors

Vision

Wireless

Lighting &

Indicators

Safety

Light Screens

Safety

Laser Scanners

Fiber Optic

Safety Systems

Safety Controllers &

Modules

Safety Two-Hand

Control Modules

Safety Interlock

Switches

Emergency Stop &

Stop Control

A-GAGE

EZ-ARRAY

™

Speciﬁcation

Serial Communication Interface

EIA-485 Modbus RTU (up to 15 nodes per communication ring)

RTU binary format

Baud Rate: 9600, 19.2K or 38.4K

8 Data Bits, 1 Stop Bit, and Even, Odd, or 2 Stop Bits and No Parity

Scan Time

Scan times depend on scan mode and sensor length. Straight scan times range from 2.8 to 26.5 milliseconds.

Status Indicators

Emitter: Red Status LED

ON Steady—Status

Flashing at 1 hz—Error

Receiver:

7 Zone Indicators

Red—Blocked channels within zone Green—All channels clear within zone

3-digit 7-segment indicators for measurement mode / diagnostic information

Sensor Status Bicolor Indicator LED

Red—Hardware Error or Marginal Alignment Green—OK

Modbus Activity Indicator LED: Yellow

Modbus Error Indicator LED: Red

System Configuration

(Receiver Interface)

6-position DIP switch: Used to set scanning type, measurement modes, analog slope and discrete output 2 function.

Alternate software GUI interface provides additional options; see full manual.

Push Buttons Two momentary push buttons for alignment and gain level selection.

Connections

Serial communication: The receiver uses a PVC-jacketed, 5-conductor 22-gauge quick-disconnect cable, 5.4 mm diameter.

QD cordsets are ordered separately. See page 343.

Other Sensor connections: 8-conductor quick-disconnect cordsets (one each for emitter and receiver), ordered separately

(may not exceed 75 m long), PVC-jacketed cordsets measure 5.8 mm diameter, have shield wire; 22-gauge conductors.

QD cordsets are ordered separately. See page 343.

Construction

Aluminum housing with clear-anodized finish; acrylic lens cover

Environmental Rating

IEC IP65

Operating Conditions

Temperature: –40° to +70° C Relative humidity: 95% at 50° C (non-condensing)

Certification

Hookup Diagrams

NPN models: MI23 (p. 763) PNP models: MI24 (p. 763)

Brackets

EZ-ARRAY™

EZA-MBK-20 SMBLBCZB

pg. 629 pg. 656

Euro QD (With Shield)

See page 689

Length

Threaded 8-Pin

Straight

4.58 m MAQDC-815

9.14 m MAQDC-830

15.2 m MAQDC-850

Cordsets

(cont’d)

Additional cordset information available.

See page 679.

Additional brackets and information available.

See page 620.

Communication Cordsets

See page 703

Length

Threaded 5-Pin

Straight Right-Angle

1.83 m MQDMC-506 MQDMC-506RA

4.57 m MQDMC-515 MQDMC-515RA

9.14 m MQDMC-530 MQDMC-530RA

Serial Adapters

See page 739 Model

USB to RS-485 serial

adapter with integral

communication cordset

and USB cable for advanced

conguration with a PC.

EZA-USB485-01

USB to RS-485 serial

adapter for advanced

conguration with a PC.

NOTE: Communication

cordset ordered separately.

INTUSB485-1

ENCLOSURES

PAGE 728

STANDS

PAGE 722

LENS SHIELDS

PAGE 732

Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 65 66

Komentáře k této Příručce

Žádné komentáře

Banner U-Gage Ultrasonic Sensor Uživatelský manuál Strana 52

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Banner U-Gage Ultrasonic Sensor